Can you replace just the axle boot?
If no noise is present and only the CV boot is broken, you can replace just the CV boot. Tip: Before you install a new axle, check the CV joints (even when the boot is broken) and see if they are worth saving. If you need to replace the CV axle completely, the new CV axle will come with the boots already installed.
Should I replace my axle boot?
Many repair shops, though, will recommend replacing the entire axle if a boot is torn because there may be unseen damage to the CV joints, axle shafts and other parts that could result in other problems. Outer boots (the ones closest to a wheel) are more prone to tears than inner boots.
How much does it cost to replace a CV axle boot?
The Average Cost for Replacing a CV Axle Is $137 to $672 Depending on if You Go to the Mechanic or DIY. This price range is based on national averages for all vehicles and does not factor in taxes, fees, or your particular make and model.
Can you drive without CV boot?
If the boot that seals the CV joint is damaged, the grease will leak out and contamination will set in, eventually causing the joint to wear out and fail. A severely worn out CV joint can even disintegrate while you’re driving and make the car undrivable. You may lose control of the vehicle entirely.
What causes a torn axle boot?
The most common cause of CV joint failure is from the deterioration and splitting or tearing of the rubber CV Boot. Once split the protective CV joint grease escapes and dirt, road grime and water can enter the joint and cause the CV joint to wear rapidly and fail prematurely.
Can a torn CV boot be repaired?
Split boot kits are a quick fix, but new boots go the distance. New or remanufactured replacement CV axle half shafts are the most efficient repair, but aren’t readily available for 30-year-old low-production turbo specialty sports cars like the 1987 Mitsubishi Starion. Before you do anything, get the axle out.
Can I glue a CV boot?
Specifically designed to be used with our CVS18 Split Boot, this CV boot glue is flexible allowing for a strong lasting bond. The 3g tube is sufficient to fully glue 1 CVS18 Split Boot.