Menu Close

What does a red light mean on a Vokera boiler?

What does a red light mean on a Vokera boiler?

has gone into lockout for safety reasons
A constant red light on your Vokèra boiler means that the unit has gone into lockout for safety reasons. Some of the possible faults behind this include: The boiler is overheating. The pump isn’t circulating hot water around the central heating system or to the taps when required.

Why is my Vokera boiler not working?

There are many possible reasons why a Vokera boiler will fail to ignite: faulty ignition leads or electrode (needed to make the spark to create the flame), blocked flue or condensate pipe, issue with the gas valve or a printed circuit board (PCB) fault.

What type of boiler is a Vokera compact 28?

The Compact 28 is a Non-Condensing Combi boiler with a maximum power output of 28.0kw that uses Gas as its fuel source.

Why is the light flashing on my boiler?

When your boiler displays a ‘C’ on the boiler screen and the burner light is also flashing, this means your boiler has reached the programmed temperature. If your house has not met the set temperature and your boiler is showing this it could be caused by a circulation problem in the system.

How do you reset your boiler?

Follow these simple instructions to reset your boiler:

  1. Refer to your boiler manual.
  2. Push the reset button for 10 seconds.
  3. Wait 2 – 3 minutes, the boiler should fire up.
  4. Repeat twice if the first attempt fails.
  5. If the boiler still fails to fire up on the third attempt, double check the gas supply.

How do you turn on the hot water on a Vokera boiler?

Turn the mode selector switch to the OFF position, switch on the electrical supply to the appliance. The green LED should be flashing, you may now select either HOT WATER ONLY or HEATING AND HOT WATER. By turning on a hot water outlet (tap) the boiler will fire to deliver hot water.

Do I need to press the reset button on my boiler?

Generally, you push the reset button and hold it down for 10 seconds. Do this only once. Wait for 2-3 minutes, as the boiler may be starting up. If the reset has been successful, then the flame will ignite in the boiler.

Posted in Cool Ideas