What is the appropriate guard for a circular saw?
Wear safety glasses or goggles, or a face shield (with safety glasses or goggles). Wear an approved respirator or dust mask when exposed to harmful or nuisance dusts. Use appropriate hearing protection equipment in noisy areas. Check the retracting lower blade guard to make certain it works freely.
What is the purpose of a spring activated blade guard on a circular saw?
To keep a spinning blade from accidentally cutting someone or marring an object, the spring-loaded retractable blade guard slides over the blade. When cutting, it should automatically retract.
What is the closest you should put your fingers to the blade while it is running?
2. Do not put your fingers closer than two inches from the blade. 3. Do not place your hands directly in line with the blade while cutting stock.
What portion of a power driven circular saw must be guarded?
29 CFR 1926.304(d) Guarding. All portable, power-driven circular saws shall be equipped with guards above and below the base plate or shoe. The upper guard shall cover the saw to the depth of the teeth, except for the minimum arc required to permit the base to be tilted for bevel cuts.
Why do you not force a circular saw cut speed?
If kickback occurs, the saw could easily jump backwards over your hand, leading to serious personal injury. speed so that the blade cuts without slowing. Forcing the saw can cause uneven cuts, loss of accuracy, and possible kickback.
Can you remove the blade guard from circular saw?
You should also remove the flange that rests between the saw blade and saw body. Use a flat-head screwdriver to pry up the guard retaining ring. Now you can pull the guard away from the saw. Use your screwdriver to pop the hooked end of the spring into the hole on the guard cover.
What is the number 1 safety rule of the band saw?
Never push on back of piece with fingers or thumb. Don’t reach across the blade. Make all cuts under power, not while blade is coasting. Never remove guard unless authorized by Technician or WRL Manager.
What should be true of the blade guards when cutting?
Keep guards in place at all times. The blade guard should be from 1/8 to ΒΌ inch above stock. Keep hands away from blade and do not open upper or lower bandsaw doors while blade is in motion. Maintain a balanced stance and keep your body under control at all times; do not overreach.
How do you cut wood with a circular saw without splintering?
There are exactly two ways to prevent splintering: increase the support between the fibers, or make the blade cut the fibers before it bends them….How to Cut Plywood With a Circular Saw Without Splintering
- Use the Right Blade.
- Use Tape.
- Make a Zero Clearance Base.
- Score the Cut Line.
- Place the Best Side Down.
How do I remove a circular saw guard?
1. Remove the saw blade
- Remove the nut that secures the blade to the saw.
- Now you can remove the saw blade.
- You should also remove the flange that rests between the saw blade and saw body.
- Use a flat-head screwdriver to pry up the guard retaining ring.
- Now you can pull the guard away from the saw.
Can you cut wet wood with a circular saw?
If you’re cutting wet wood set the depth so that the entire gap between the teeth is clear of the board you’re cutting. This will stop your saw and cut line from getting clogged with wet saw dust.