What is WIC Cisco?

What is WIC Cisco?

A WAN interface card, or “WIC” is a type of specialized network interface controller card (NIC) made by Cisco that allows a network device such as a router to connect and transmit data over a wide area network.

What is WIC 1T?

The 1−port serial WAN interface card (WIC−1T) provides serial connections to remote sites or legacy serial network devices such as Synchronous Data Link Control (SDLC) concentrators, alarm systems, and packet over SONET (POS) devices.

What is WIC 2T?

WIC-2T Cisco 2-Port Serial Wan Interface Card. The dual serial port WIC-2T provides higher levels of serial port density than a single WAN interface card and is supported on the Cisco 2600 series and supports speeds of up to 2.048Mbps.

What does Hwic mean?

High Speed Wan Interface Card. HWIC.

What are main Cisco IOS command modes?

There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode.

What is NIM 2T?

NIM-2T Cisco Router High-Speed WAN Interface card. Detail: 2-Port Serial WAN Interface card.

Which router mode should I use?

Radio mode It’s usually best to enable every mode offered by your router, rather then a subset of those modes. All devices, including older devices, can then connect using the fastest radio mode they support. This also helps reduce interference from nearby legacy networks and devices.

Which operation mode is best for router?

There are four operating modes in the router settings — the main mode and three additional modes:

• Router (A) — main mode;
• Adapter (B) — connect Ethernet devices to a Wi-Fi network;
• Repeater/Extender (C) — Wi-Fi extension;
• Access point/Extender (D) — expansion of the Wi-Fi area with Ethernet connection.

What are main Cisco command modes?

There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode. After an EXEC session is established, commands within Cisco IOS Software are hierarchically structured.

How do I access my Cisco router via console cable?

Access Router Command Line Interface

1. Under Category, choose Session.
2. Under Connection type, choose Serial.
3. In the Serial line, enter the COM port on your laptop that is connected to the console port on your router, using the console cable.
4. Click Open.

How do I make my router internet faster?

How To: Get the best wireless router settings for your home

1. Change the default password.
2. Change the default IP address.
3. Set the DHCP server mode to disable.
4. Set up the wireless network.
5. Set the wireless channel.
6. Disable the Wireless SSID broadcast.
7. Enable the WPS or SES mode.
8. Set up the wireless security.