How does a PTZ controller work?

Using a network PTZ joystick controller, you can control PTZ cameras by simply connecting the controller to a security video recorder with a single network cable. This provides hands-on control over your PTZ camera with a setup that takes only minutes to complete.

Table of Contents

How do I connect my PTZ camera to my joystick controller?

Press the Cam 1 button.
Hold down the Setup button. (
Set cam 1 to be VISCA, 9600 baud rate.
Select Cam Set and press Enter.
Press enter while the joystick is blinking on Cam 1.
You should now be able to select VISCA as the Protocol, and 9600 as the baud rate.
Repeat this for any additional cameras.

How do you control a PTZ camera?

PTZ cameras can be controlled in a variety of ways including an IR remote, a joystick controller, and software. IR remote controls usually offer a limited set of basic features for controlling the camera and recalling presets.

How do I setup my PTZ camera?

Step by step process:

Step one: Connect your camera to the network.
Step two: Either set a static IP address or set the camera to DHCP.
Step three: Use the IR remote shortcuts to verify your cameras IP address.

Are dome cameras better than bullet?

Both cameras will operate well in any location, however, the bullet camera will work better for a long-range video while the dome camera will work better for shorter distances but a wide-angle. Both dome and bullet cameras include LEDs that allow the camera to see in dark or low-light situations.

How do I connect my PTZ camera to my DVR?

Steps to connect the PTZ to the DVR

Connect the video and power cable on the PTZ camera’s pigtail to your DVR using a coaxial/power cable.
Connect the RS485 of your PTZ camera into the DVR.
Match the DIP switch of the PTZ camera.
Configure baud rate and protocol in the DVR.

How do I connect my PTZ camera to my computer?

For PTZ camera, it has a RS485/422 port to plug in the control cable. In order to connect a PTZ camera to a computer, You need a RS485/RS232 or RS422/RS232 converter. If there is no RS232 port on your computer, you also can use a RS485/USB or RS422/USB converter.

What is PTZ activation?

● Triggered PTZ activation means that the PTZ camera will go to the preset. position when triggered by the event.

Is bullet camera better than dome camera?