What is a warm start on a UPS?
A “System: Warmstart” alert means that the Network Management Card (NMC) has restarted without losing power.
How do I reset my NMC apc?
1.) Hold down the Reset button for 20-25 seconds, ensuring the Status LED is pulsing green during this time. 2.) When the Status LED change to amber or orange, release the Reset button to allow the NMC to complete its reboot process.
What is the default password for Schneider Electric UPS?
The default user name is device, and the default password is apc.
How do I reset my APC password?
Press the Reset button a second time immediately while the LED is flashing to reset the user name and password to their defaults temporarily. Then press ENTER as many times as necessary to redisplay the User Name prompt, then use the default, apc, for the user name and password.
Why is a cold start louder?
When it is cold, more fuel is added to the air/fuel mixture to make up for the lack of natural vaporisation. So the AFR (air-fuel ratio) is seen by the ECU to be leaner than usual (below the Stoichiometric ratio of 14.7:1) so it compensates for this with extra fuel to make up for the unburned fuel due to the cold.
What is the difference between a cold start and a warm start?
Cold Start: Cold start refers to starting the CPU from power off,Current configuration is discarded and program processing begins again with the initial values. Warm Start: Warm start refers to restarting the CPU without turning the power off, Program processing starts once again where Retentive data is retained.
Is Revving a cold engine bad?
Revving the engine won’t speed up the process. In fact, that could cause easily avoided damage. Cold revving causes abrupt temperature changes that create stress between the engine’s tight-fitting components.
How long do APC batteries last?
three to five years
Most APC batteries should last three to five years. There are many factors which affect Battery life including environment and number of discharges.
What does coldstart and warmstart mean on the NMC?
A “System: Coldstart” alert means that the Network Management Card (NMC) has just been powered; this may happen if the device powering the Network Management Card suffers an interruption of power. A “System: Warmstart” alert means that the Network Management Card (NMC) has restarted without losing power.
What is the difference between coldstart and warmstart alerts on ups?
Your UPS load is unaffected. A “System: Coldstart” alert means that the Network Management Card (NMC) has just been powered; this may happen if the device powering the Network Management Card suffers an interruption of power. A “System: Warmstart” alert means that the Network Management Card (NMC) has restarted without losing power.
What does the system warmstart event indicate?
A System Warmstart (or restart) event indicates that the NMC has rebooted and completed startup, without losing power. This may be due to any of the conditions mentioned below. The default gateway is wrong or the network traffic is too heavy and the gateway can not be reached.
What does the embedded NMC within the ups monitor?
The embedded NMC within the UPS must be used to monitor any power distribution. Galaxy 300/7000* *Ships with AP9630 pre-installed in units manufactured post 2012. Older G7000 models require a special upgrade kit pre-2012 manufacture date.