Why is my Westinghouse dishwasher not working?
Check if the plug is connected. Check your indoor fuses, Be sure that the water inlet tap is turned on, ae sure that you have closed the machine door Be sure that you switched off the machine by pressing the Power On/Off button Be sure that the water inlet filter and the machine filters are not clogged.
Why is my Westinghouse dishwasher flashing?
If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. To determine if the heating element has burned out, use a multimeter to test it for continuity. If the heating element does not have continuity, replace it.
Why is my Westinghouse dishwasher flashing F2?
If your dishwasher doesn’t drain properly, you’ll see standing water on the bottom of the dishwasher when the cycle is complete and the error code F2 may be displayed, according to the Westinghouse dishwasher user manual.
What causes a dishwasher to not turn on?
If the dishwasher won’t do anything at all, the problem could be the power supply. Check the circuit breaker. If it has tripped, flip the switch to the “off” position and then turn it back on. If the circuit has not tripped, check to ensure that the appliance is properly plugged into its wall outlet.
What does F5 mean on my dishwasher?
Insufficient water
F5 – Insufficient water Check that the water inlet hose is clean and not blocked or kinked. 3. If the problem persists, press the power button to turn the dishwasher off. Unplug the dishwasher from the mains.
What does e2 and F2 mean on a dishwasher?
Whirlpool gold series dishwasher error code e2/ f2, means main control board is not getting correct signal from the user interface. Turn off power/breaker, remove screws holding inner door liner, remove liner and check/secure/clean all wire connections from front interface and main control board.
Where is your dishwasher filter located?
Where is the dishwasher filter? The dishwasher filter is at the bottom of your dishwasher, under the bottom rack. To find it, pull out the bottom dish rack, then look for the filter—it’s usually either in one of the back corners of the dishwasher tub or around the base of the bottom spray arm.
How do I fix my F5 fault Bush dishwasher?
F5 – Insufficient water
- Ensure the water inlet tap is in the open position.
- Check that the water inlet hose is clean and not blocked or kinked.
- If the problem persists, press the power button to turn the dishwasher off.
- Unplug the dishwasher from the mains. If the product is within warranty, contact your retailer.
Why is my dishwasher flashing E2?
Maytag Dishwasher F2 E2 Error Code Meaning If this code appears on your dishwasher display, it means that there is a communication failure between the electronic control and the touchpad.